Sunlite Science and Technology

Pioneering LED Illumination
It is currently August 14th, 2022, 7:46 am

All times are UTC - 6 hours [ DST ]




Post new topic This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 
Author Message
PostPosted: June 25th, 2012, 10:28 am 
Offline
Administrator

Joined: February 13th, 2011, 12:32 am
Posts: 82
Question
Need UV 365nm light to cure adhesives to bond polycarbonate to aluminum. curing area needs be a little over 1 inch. curing time needs to be less than 2min. thickness of the adhesive is around 1/16 inch. which light do you recommend.

Answer
8WFP UV-365 LED is recommended. at a distance of 1 inch, the center spot is 1.4 inches. This strong center spot typically cures Loctite UV curing adhesives in less than 1 min.

This 8WFP UV-365 LED can be powered by a portable flashlight power units with 3 AAA batteries (initial current 700mA), 2 CR123 batteries (constant current 1A) or 1 Rechargeable 2200mAh Lithium battery (initial current 1.2A).
This 8WFP UV-365 LED can also be powered by AC adapter (constant current of 1.2A), in the Workstation Light setup, or Twin-light setup. Using the workstation setup, light can be powered either by the rechargeable lithium battery, or directly powered by the AC adapter (the adapter is also used to charge the battery).

If the 8WFP UV-365 LED is not strong enough, we can make a 12WFP UV-365 that will work with the same power source as 8WFP. 12WFP is 1.4 times brighter than 8WFP.

The image for the workstation setup:
Image

The image for the Twin_light setup:
Image


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group
Americanized by Maƫl Soucaze.